BK Resources VFTS-1824 Stainless Steel Filler Table 18" x 24", 1-1/2" Riser, Galvanized Legs and Undershelf
The BK Resources VFTS-1824 is a 18" wide, 24" deep filler table with an 18 gauge T-430 stainless steel top, a 1-1/2" rear riser, galvanized legs and an adjustable galvanized undershelf. The work surface is 34-3/4" high and the riser brings it to 36-1/4" overall. BK Resources list price is $260.
Key Specs at a Glance
| Model | VFTS-1824 |
| Size | 18" L x 24" W, 36-1/4" overall height |
| Top | 18 gauge T-430 stainless steel, 1-1/2" rear riser |
| Base | Adjustable galvanized undershelf, galvanized legs |
| Feet | Adjustable high-impact corrosion-resistant feet |
| Product weight | 32 lb (BK spec sheet) |
| List price | $260 |
What a Filler Table Does
A filler table closes the gap between two pieces of equipment on a cooking line, or between equipment and a wall, so there is no open slot for food and grease to fall into. At 18" wide it gives you a landing spot for plates, pans and tools right where you need it.
Measure the gap carefully and choose the filler that fits it. Set the feet so the top lines up with the equipment next to it. The rear riser keeps items from sliding off the back.
Compare Sizes
| Model | Size (L x W) | List price |
|---|---|---|
| VFTS-1524 | 15" x 24" | $255 |
| VFTS-1824 | 18" x 24" | $260 |
| VFTS-1530 | 15" x 30" | $271 |
| VFTS-1830 | 18" x 30" | $274 |
| VFTS-2430 | 24" x 30" | $351 |
Sizing a Filler Table
Measure the gap at the floor and at counter height; walls and equipment are not always plumb. Choose the filler that fills the space without forcing it in, and level it so the top lines up with the equipment beside it. Leave the clearance your equipment manufacturer requires from combustible surfaces and heat sources.
Where It Fits
- Between a fryer and a range on the cooking line.
- At the end of a line, beside a wall.
- Next to a prep sink as a landing spot.
- Between refrigeration and a work table.
Cleaning and Care
- Wipe stainless steel with warm water and a mild detergent, then rinse and dry. Wipe in the direction of the grain.
- Avoid steel wool, wire brushes and chlorine bleach; they scratch the surface or cause pitting and rust spots.
- Dry galvanized parts after wet cleaning so the zinc coating lasts longer.
- Check the feet and fasteners now and then and re-level the table if it starts to rock.
Before You Order
- Measure the gap: this filler is 18" wide and 24" deep.
- Check the height of the equipment on each side.
Documents
Frequently Asked Questions
What size is the VFTS-1824?
18" wide and 24" deep.
What is a filler table?
A narrow table that fills the gap between equipment or between equipment and a wall.