Skip to content

BK Resources SFTS-2430 Stainless Steel Filler Table 24" x 30", 1-1/2" Riser, Stainless Legs and Undershelf

Original price $597.00 - Original price $597.00
Original price
$597.00
$597.00 - $597.00
Current price $597.00

The BK Resources SFTS-2430 is a 24" wide, 30" deep filler table with an 18 gauge T-430 stainless steel top, a 1-1/2" rear riser, stainless steel legs and an adjustable stainless steel undershelf. The work surface is 34-3/4" high and the riser brings it to 36-1/4" overall. BK Resources list price is $597.

Key Specs at a Glance

Model SFTS-2430
Size 24" L x 30" W, 36-1/4" overall height
Top 18 gauge T-430 stainless steel, 1-1/2" rear riser
Base Adjustable stainless steel undershelf, stainless steel legs
Feet Adjustable high-impact corrosion-resistant feet
Product weight 43 lb (BK spec sheet)
List price $597

What a Filler Table Does

A filler table closes the gap between two pieces of equipment on a cooking line, or between equipment and a wall, so there is no open slot for food and grease to fall into. At 24" wide it gives you a landing spot for plates, pans and tools right where you need it.

Measure the gap carefully and choose the filler that fits it. Set the feet so the top lines up with the equipment next to it. The rear riser keeps items from sliding off the back.

Compare Sizes

Model Size (L x W) List price
SFTS-1530 15" x 30" $526
SFTS-1830 18" x 30" $550
SFTS-2430 24" x 30" $597

The galvanized version of this size is the VFTS-2430 ($351).

Sizing a Filler Table

Measure the gap at the floor and at counter height; walls and equipment are not always plumb. Choose the filler that fills the space without forcing it in, and level it so the top lines up with the equipment beside it. Leave the clearance your equipment manufacturer requires from combustible surfaces and heat sources.

Where It Fits

  • Between a fryer and a range on the cooking line.
  • At the end of a line, beside a wall.
  • Next to a prep sink as a landing spot.
  • Between refrigeration and a work table.

Cleaning and Care

  • Wipe stainless steel with warm water and a mild detergent, then rinse and dry. Wipe in the direction of the grain.
  • Avoid steel wool, wire brushes and chlorine bleach; they scratch the surface or cause pitting and rust spots.
  • Dry galvanized parts after wet cleaning so the zinc coating lasts longer.
  • Check the feet and fasteners now and then and re-level the table if it starts to rock.

Before You Order

  • Measure the gap: this filler is 24" wide and 30" deep.
  • Check the height of the equipment on each side.

Documents

Frequently Asked Questions

What size is the SFTS-2430?

24" wide and 30" deep.

What is a filler table?

A narrow table that fills the gap between equipment or between equipment and a wall.

Compare products

{"one"=>"Select 2 or 3 items to compare", "other"=>"{{ count }} of 3 items selected"}

Select first item to compare

Select second item to compare

Select third item to compare

Compare